Hi,
i was playing around with the pogoplug V4 in uboot and found the nice sntp (and other) commands to setup time during boot. I tried that on the Pogoplug V3, but the exisiting SATA uboot version does not support these commands.
I looked at https://forum.doozan.com/read.php?3,16017,page=1 for creating a new uboot to boot from SATA (not for flashing), but it is not very straight forward for me and i have a few question:
1. Can i compile the uBoot from https://github.com/mibodhi/u-boot-oxnas on any computer or it has to happen on an arm device?
2. Is there any base config where i can start from? If not what should i set in the menu config to compile it for oxnas?
3. As i know by default it creates a flashable image. What do i need to change to get a image usable for SATA boot?
I am pretty new for uBoot maybe there is a good guide for it but i did not find it so far.
Thanks
i was playing around with the pogoplug V4 in uboot and found the nice sntp (and other) commands to setup time during boot. I tried that on the Pogoplug V3, but the exisiting SATA uboot version does not support these commands.
I looked at https://forum.doozan.com/read.php?3,16017,page=1 for creating a new uboot to boot from SATA (not for flashing), but it is not very straight forward for me and i have a few question:
1. Can i compile the uBoot from https://github.com/mibodhi/u-boot-oxnas on any computer or it has to happen on an arm device?
2. Is there any base config where i can start from? If not what should i set in the menu config to compile it for oxnas?
3. As i know by default it creates a flashable image. What do i need to change to get a image usable for SATA boot?
I am pretty new for uBoot maybe there is a good guide for it but i did not find it so far.
Thanks