LaCie NS2 - *** Warning - bad CRC, using default (1 reply)
Hi! Updated u-boot, environment variables are lost. Connected via UART. After rebooting, the CRC error appears again and the variables are not saved. Tried commands "env default -a", "saveenv", "env...
View ArticleNeed Help Unbricking a Goflex Home (1 reply)
Hi, I recently acquired a Goflex Home box. I also have one that I have had since new about 2015. This one is one just got when powered on the light flashes green then turns to flashing red and never...
View ArticleDebian-6.5.7 on NSA325 (1 reply)
Hello everyone, I got a NSA325 for free and want to install Debian on it. I followed the tutorials and could successful flash u-boot 2023.04 Kirkwood onto it. Then I followed this tutorial...
View ArticleRepair bricked Readynas rn10400(rn104) (no replies)
Hi All, My nas works on OS 6.1.9. After power fails nand chip is blank and damaged. I bought a new NAND, the same as the one installed. Now whenever I power on my NAS in terminal I am getting...
View ArticleBricked Zyxel NSA320S - need help, please (no replies)
Can I revive (reanimate) the NSA320S, please provide some tutorial that will allow me to create a pendrive or upload Debian via com to the NSA320S memory. This is how I disassembled it to its first...
View ArticleUnbrick Stora MS2000 (no replies)
Hi guys! I tried to switch to openwrt on my Stora MS2000 I did everything according to the instructions, but at step tftp 0x0800000 u-boot.kwb nand erase 0x0 100000 nand write 0x0800000 0x0 0x100000...
View Articlekirkwood uboot for dlink dns-325 (1 reply)
@bodhi, In the topic u-boot for d-link dns35, you provide u-boot for the device but with the warning not to flash to nand. I have DLed the u-boot and have been able to boot via UART and there was much...
View ArticleHave I completely damaged the Zyxel NSA320S? (1 reply)
Have I completely damaged the Zyxel NSA320S? There is currently no reaction, The blue LED lights up when I connect the power supply. You do not turn on, you do not react... Brak połączenia po COM
View ArticleNAS WD EXT2ultra brické (no replies)
bonjour a tous, j'ai un NAS WD ext2 ultra HS, et lorsque je me connecte avec putty avec un USB UART j'ai un tas de chiffre et lettre qui défile dans putty. Le bouton reset est inopérant impossible...
View ArticleNSA325v2 bricked (no replies)
Hello, I recently got my hands on an NSA325v2 Zyxel NAS and I wanted to install debian on it. I followed the various procedures but I think I bricked my NAS. I tried connecting it via serial UART: usb...
View ArticlePogoplug mobile, usb port problem (3 replies)
Hi all I flashed 2017 uboot for pogoplug v4 and 2016 envs. Made rootfs on usb stick but uboot does not detect usb sticks, tried sandisk and kingston sticks. However led light on usb stick turns on....
View ArticleZYXEL NSA310S bricked... (1 reply)
Hi. I tried to install Debian on my ZYXEL NSA310S device and I must have done something wrong. Now the device does not work and I cannot communicate via UART. Can anyone help me? How to fix UART...
View Article2024.10 U-Boot Kirkwood - DNS-325 (no replies)
2024.10 U-Boot Kirkwood - DNS-325 This instruction is under tested. Please wait until I remove this warning. ========================================= Update 09 Apr 2025 Download at Dropbox I have not...
View ArticlePogoPlug E02 doesn't boot (no replies)
It's been a long time since I used Pogoplug, so I wanted to reinstall everything from scratch to update it. I just updated my uBoot, which was a mistake. I think I bricked it. When it boots, I don't...
View ArticleCompletely bricked u-boot on PogoPlug v4 Mobile (4 replies)
I've completely bricked u-boot on my PogoPlug v4 Mobile. I was attempting to upgrade it via serial + tftp, but clearly messed it up. Now, I'm getting literally no output from the serial connection,...
View ArticleUsing 2015.10 U-Boot for Pogoplug V3 (OXNAS OX820) with AKiTio MyCloud Mini...
I have been following this forum for some time and have been using the SATA boot version of 2013.10 U-Boot for OXNAS on my AKiTio MyCloud Mini. However, the AKiTio MyCloud Mini cannot boot with a...
View ArticleZyxel 325v2 (1 reply)
Hello, I'm currently trying to reinstall my Zyxel 325v2 with Debian and am following these instructions: https://forum.doozan.com/read.php?3,12381 Unfortunately, I don't have flash_erase /dev/mtd0 0...
View ArticleHelp with UART Pins of DS415+ (1 reply)
I need the pinout for the DS415+ UART port. I need to know the GND, TX, RX, and 3.3V pins, assuming I'm looking directly at the connector. The row of 3 pins closest to the motherboard is row 1 and the...
View ArticleDS418J no ethernet (no replies)
Hello all, A friend gave me a DS418J for repair. The ethernet slot is dead, there is no link created and the NAS is not recognized on the network. I tried : - hard reset - with and wiohout hard disk -...
View ArticleHelios64, tftpboot (no replies)
I'm trying to load files over tftp to my Kobol Helios64. This box has 2 ethernet ports, one 2.5Gbit, and one 1Gbit. When I give any network related command, it gives a repeated 'dw_dm_mdio_init: mdio...
View Articlecan't stop autoboot via uart Iomega ix2-dl(ng) (1 reply)
Hello, I want to flash my ix2-dl(ng) to openwrt. To do this, I need to stop the “autoboot” process during the boot phase. But I can't do this because the device simply does not respond to any...
View ArticleZyxel NSA325 messed up uboot - recovery - de-brick (2 replies)
@brodhi i have a 2nd nsa325 which i fu**ed up some years ago while flashing uboot (maybe corrupt). now i tried to kwboot it but it works only parcially: Zyxel-NAS325-OpenWRT$ kwboot -t -B 115200...
View ArticlePogoplug V4 wont boot from SD on uBoot 2023.04 (no replies)
Hello there, i recently got a fully new Pogoplug V4 from work and decided to install debian and stuff, used my Pi1 for TTL and i manage to make it work, only issue is that the SD didnt boot unless i...
View ArticleIs this NSA320 bricked? (no replies)
Sorry for all the posts, I really thought everything would be OK. Everything was going OK, I was using rsync to copy data files to the new hard drive, middle of the night we lost power, I was able to...
View ArticleLenovoEMC HMEZ (no replies)
Hello I'm new to this forum and think I've come to the right place. I've been trying to get my LenovoEMC HMEZ up and running again for days. I've tried various options, but unfortunately all my...
View ArticleQNAP TS-228A RTD1295 (no replies)
Hi there! I would like to modify my the boot device on the TS-228A to exchange my old NAS326. My first goal would be to boot Linux on a flash drive. IIRC this SoC pretty much gained mainline support...
View ArticlePogoplug V4: Bad eraseblock 2 at 0x000000040000 (no replies)
I have a Pogoplug Mobile with a bad eraseblock 2, and another with a bad eraseblock 3. I was reading U-Boot: dmesg | grep -i 'bad' --> Bad eraseblock 72 at 0x000000900000 which says there is a work...
View ArticleStock env for Zyxel NSA310 (no replies)
Hello all, is here somebody who has backup of the original env from stock firmware Zyxel NSA310? Thanks for any advice.
View Articlesynology DS920+ unbrick boot (no replies)
Hi, I am stuck trying to fix the Synology DS920+ BIOS, which does not boot and just has a blinking blue light. I have read the BIOS from the original chip; it is 16 MB, but the new file I got from the...
View ArticleIomega ix2-200ng U-boot needed (no replies)
Hi Bodhi, thanks for you help! I have prepared a linux host with UART USB-TTL and I have used kwboot and pococom and expect to save job but have received only Sending boot message.Please reboot the...
View Article