Pogoplug V4 Troubleshooting Help (1 reply)

I'm having issues with my Pogoplug not always booting and I would appreciate some help/advice on the boot issues I'm having.
It will not boot at all with the usb removed, just a green flashing light, it takes several attempts to boot with the usb attached, usually my ssh commands are rejected and I know it finally boots OK when I login using alarm/alarm.

I'm using it to mount network drives and a printer, but I can't access it all other than by ssh. There is definately a mount issue.

My system consists of the following:

PogoPlug V4_A3_01
[alarm@pogoplug ~]$ uname -a
Linux pogoplug 4.4.47-1-ARCH #1 PREEMPT Sat Feb 4 21:22:22 MST 2017 armv5tel GNU/Linux

I have the following dmesg issues that I don't know how to fix

[ 13.956487] systemd-fstab-generator[117]: Checking was requested for "\xffffffd2LABEL=ROOTFS", but it is not a device.
[ 13.987456] systemd-fstab-generator[117]: Mount point is not a valid path, ignoring.
[ 14.581156] systemd[1]: local-fs.target: Cannot add dependency job, ignoring: Unit -.mount is not loaded properly: Bad message.
[ 16.109798] systemd-journald[146]: File /var/log/journal/3c32b83380384c598b0687f3a7f01a67/system.journal corrupted or uncleanly shut down, renaming and replacing.
[ 17.623424] MV-CESA:Could not register sha1 driver
[ 17.673465] MV-CESA:Could not register hmac-sha1 driver
[ 22.776525] hbwd (245): /proc/245/oom_adj is deprecated, please use /proc/245/oom_score_adj instead.

I have attached the whole file if that helps.

I'm trying to fix without going back to stock and starting from scratch.

Any help would be appreciated thanks