Pogoplug Mobile no light/ssh/serial connection (10 replies)

Hi, I am new here so I hope I'm posting this in the correct place. I have a pogoplug Mobile that I was experimenting with. I started by following this tutorial http://blog.qnology.com/2014/07/hacking-pogoplug-v4-series-4-and-mobile.html?m=1

The device was new so I needed serial console access. I got serial access and changed the rcS file to start up dropbear and disable the pogoplug services. Then I followed the tutorial from ssh.

I self hosted the files from a git mirror and pulled them in wget. I followed all the way up to the section of installing Debian /alarm. I didn't start this step yet. Everything looked good and on all my flashes I got a success.

Before I was about to start the Linux install, I rebooted the device. That's when it never came back up. I did up to this point with no usb or sd card in. I did do the netconsole part of the tutorial. I literally copied the exact commands from the tutorial. However my network is on 192.168.0.1.

When I rebooted I ran /sbin/reboot command. No lights ever came back on. I also tried connecting back to the serial console and nothing was loading there either.

Is this something I can save? And where did I probably go wrong?